10
crank time setting has been increased by
one step.
6. Release the valet switch to exit.
7. Test remote starter and if necessary
repeat steps 1-6.
Gas and Diesel Modes
The default engine type setting is
Gasoline
.
For diesel vehicles, the engine type must be set
to one of the three
Diesel
options. If a glow
plug wire is not available, the unit has a built-in
timer that waits 15 seconds before cranking the
starter. For vehicle’s with a glow plug light
(wait-to-start indicator) the BLUE wire should
be connected to verify the glow plugs are warm
before the engine begins cranking.
ADDING TRANSMITTERS
To add a new transmitter to the system have
the desired transmitters ready and follow the
Code Learning sequence.
To enter Code Learning Mode:
1. Within 3 seconds, turn the ignition on, off,
on, off and leave on.
2. Press and hold the Valet switch.
• The parking lights will turn on.
• The horn will honk once (optional).
3. Continue to hold the Valet switch.
• The parking lights will turn off.
• The horn will honk 5 times (optional).
4. Release the Valet switch.
5. Press Button 1 on the transmitter.
• The parking lights will flash and horn will
honk (optional).
6. Repeat step 5 for each additional
transmitter, up to four total transmitters.
7. Turn off the ignition.
NOTE: If a transmitter is lost or stolen, make sure
to code all 4 transmitter memory locations.
(Example: If only one transmitter is used, repeat
step 3 three more times to remove any
previously programmed transmitters.)
RELAY WIRING DIAGRAMS
TRUNK RELEASE DIAGRAM
ANTI-GRIND RELAY
BW651 final.qxd 10/18/2005 10:58 AM Page 10
