5
seconds after the ignition is turned off and
anytime button 1 is used to lock the doors.
• WHITE/BLUE WIRE - Horn output (-)
250mA. Connect to an optional relay to
activate the vehicle’s horn. The horn output is
programmable for pulse duration and to set
which functions will trigger the horn pulses.
• BLACK/WHITE WIRE - Not used.
• VIOLET WIRE - Not used.
• WHITE WIRE - Parking Light output (+) 10A
relay. Connect to the vehicle’s parking light
wire. If the vehicle is equipped with more than
four parking lights or with independent left and
right parking light circuits a relay is required.
For vehicle’s with negative trigger parking lights,
the RED/WHITE trunk release wire can instead
be programmed for use as a negative parking
light output if needed, and the WHITE wire
output then becomes a positive trunk release
output. See
Programmable Features
NOTE: Do not connect the parking light output
to the vehicle’s headlight circuit.
• GREEN/WHITE WIRE - Hood trigger input
(-). Connect to the hood pin switch that shows
ground when the hood is open.
• GREEN WIRE - Not used.
• BLACK WIRE - Ground input (-). Connect to
a chassis ground that is free of paint or dirt.
• PINK WIRE - Brake switch input (+).
Connect this wire to the brake switch wire that
pr12V when the brake pedal is pressed.
• BLUE/WHITE WIRE - Tachometer input
(A/C). Connect to the vehicle’s coil, fuel
injector or crank sensor wire.
• BLUE WIRE - Glow plug light input (+/-). For
diesel vehicles without a glow plug wire, no
connection is needed. A 15-second timer will
engage before cranking the starter. Most diesel
vehicles will have a glow plug wire located in the
instrument cluster. For these vehicles, test the
wire to confirm proper operation and connect
to it. Negative glow plug wire systems will show
+12V when the the glow plug (wait-to-start)
light is on, then show ground when the light
turns off. Positive glow plug wire systems will
show ground when the wait-to-start light is on.
The BLUE wire is programmable for the system
polarity and should be connected directly to the
glow plug wire. See
Programmable Features
6-Pin Starter Harness
• YELLOW WIRE - Start output (+). Connect
to the vehicle’s starter wire.
• GREEN WIRE - Main accessory output (+).
12V output for heater and/or air conditioning
system. For cars with more than one accessory
wire add a relay(s) to power the extra
accessory wire(s) or if the WHITE wire is not
being used, it can be programmed for second
accessory output.
• RED WIRE - Main power input (+). Using the
supplied inline fuse holder, connect directly to
the vehicle’s battery or alternate power source
with a minimum 30 Amp supply.
• RED WIRE - Main power input (+). Using the
supplied inline fuse holder, connect directly to
the vehicle’s battery or alternate power source
with a minimum 30 Amp supply.
• BLUE WIRE - Main ignition output (+).
Connect to the main ignition wire that switches
+12 V and does not drop out during cranking.
• WHITE WIRE - Second ignition output (+).
Connect to the wire that sw12V and
does not drop out during cranking. This wire
may be optionally set via jumper for use as a
second accessory wire or second starter wire.
Remove top of housing and see
Jumper Settings.
Module Connectors
3-Pin White Connector:
Plug-in connector for
door locks.
• GREEN WIRE - Lock output (-) 500mA.
BW651 final.qxd 10/18/2005 10:58 AM Page 5
