© Black Mountain Bikes
SETTING UP: INSERTING THE SEAT
01
02
04
03
Open the quick-release seat clamp and unwind
the hand-nut a couple of turns to fully release
the clamp.
Insert the seatpost ensuring the saddle is at the
correct height. The rider should be able to touch
the ground with the balls of their feet when seated.
Once you are happy with its position, tighten the
hand-nut "finger tight" and then close the quick-
release lever. This should leave a slight imprint in
your hand, but no more.
Check the quick-release clamp is tight enough
by attempting to twist the saddle. If it is not tight
enough, turn the hand-nut a quarter turn
and retry.
WARNING:
There is a minimum insertion mark on the seat post. Do
not raise above this mark, it must not be visible. Also, please make sure
your child can touch the ground with the balls of both feet.
If not, adjust the seat height accordingly.
MIN INSERTION MARK
MUST NOT BE VISIBLE.
SEE WARNING BELOW
24
Kapel_Hutto_Manual OCT2019ALv3.indd 24
28/11/2019 14:13
