P47 - THUNDERBOLT.
INSTRUCTION MANUAL.
19
3) Mark the shape of the vertical on the left
and right sides of the rudder using a left-tip
pen.
2) Put the rudder into the fuselage as same
as picture below.
4. Now, remove the rudder and using a
modeling knife, carefully cut just inside the
marked lines and remove the film of the rud-
der. Just as you did with the horizontal stabi-
lizer, make sure you only press hard enough
to cut the film, not the balsa rudder.
Pen.
Also carefully remove the covering from
below the lines as you drew as same picture
below.
Remove covering.
1) Using a modeling knife, cut away the
covering from the end of fuselage for the rudder
hing.
VERTICAL STABILIZER.
C/A glue
C/A glue
Hinge.
Remove covering.
Remove covering.
