P47 - THUNDERBOLT.
INSTRUCTION MANUAL.
24
3) Secure the tail wheel bracket in place
using three 3mm x 12mm wood screws. Be
careful not to overtighten the screws.
2) Using a pen, mark the locations of the
two mounting screws. Remove the tail wheel
bracket and drill 1mm pilot holes at the loca-
tions marked.
Install adjustable servo connector in the
servo arm.
After installing the adjustable metal con-
nector apply a small drop of thin C/A to the
bottom nut. This will prevent the connector from
loosening during flight.
Rudder
cable.
PUSHROD THROTTLE SERVO
INSTALLATION.
Servo arm.
Connector.
1) Set the tail wheel assembly in place
on the plywood plate. The pivot point of the
tail wheel wire should be even with the rud-
der hinge line and the tail wheel bracket should
be centered on the plywood plate.
MOUNTING THE TAIL WHEEL BRACKET.
Rudder
servo.
Throttle servo.
Elevator servo
.
Throttle
pushrod
Elevator servo.
3 x 12mm
