Instruction Manual.
5
1) Thread one nylon adjustable control
horn onto each aileron torque rod. Thread the
horns on until they are flush with the ends of
the torque rods.
2) Thread one nylon clevis at least 5/16”
onto each of the two 2mm x 100mm threaded
wires.
6) Using a modeling knife, carefully remove
the covering from servo mount.
Remove covering
7) Install the aileron servo into the servo
mount, with the output shaft towards the lead-
ing edge of the wing, using the wood screws
provided with your radio system. Drill 1/16”
pilot holes through the mount before installing
the screws. This will prevent the wood from
splitting.
Aileron servo.
2)
Test fit the aluminium dihedral brace
into each wing half. The brace should slide in
easily.
WING ASSEMBLY.
1) Location the aluminium wing dihedral
brace.
Aluminium.
INSTALLING THE AILERON LINKAGE.
Epoxy glue
