EP-TRAINER.
16
1) Using a modeling knife, remove the
covering from over the two main gear mount-
ing slots located in the bottom of the fuselage.
2) Using the two landing gear straps as a
guide, mark the locations of the four mount-
ing screws onto the fuselage surface.
3) The landing gear wire is held in place
using two nylon landing gear straps and four
wood screws.
MAIN GEAR INSTALLATION.
3) Do not permanently secure the re-
ceiver and battery until after balancing the
model.
4) Using a 2mm drill bit, drill a hole through
the side of the fuselage, near the receiver, for
the antenna to exit.
Remove covering
Secure.
1) Plug the servo leads and the switch
lead into the receiver. You may want to plug
an aileron extension into the receiver to make
plugging in the aileron servo lead easier
when you are installing the wing . Plug the
battery pack lead into the switch.
2) Wrap the receiver and battery pack in
the protective foam to protect them from vi-
bration. Use a rubber band or masking tape to
hold the foam in place.
INSTALLING THE RECEIVER AND BATTERY.
3 x 12 mm
Nilon strap
Collars
Secure
