Instruction Manual.
13
VERTICAL STABILIZER INSTALLATION.
Hinge.
Remove covering
.
Pen.
Remove covering
.
1. Using a modeling knife, remove the
covering from over the precut hinge slot cut
into the lower rear portion of the fuselage. This
slot accepts the lower rudder hinge.
2. Slide the vertical stabilizer into the slot
in the top of the fuselage. The rear edge of
the stabilizer should be flush with the rear edge
of the fuselage and the lower rudder hinge
should engage the precut hinge slot in the
lower fuselage. The bottom edge of the stabi-
lizer should also be firmly pushed against the
top of the horizontal stabilizer.
3. While holding the vertical stabilizer
firmly in place, use a pen and draw a line on
each side of the vertical stabilizer where it
meets the top of the fuselage.
Hinge slot
4. Remove the stabilizer. Using a model-
ing knife, remove the covering from below the
lines you drew. Also remove the covering from
the bottom edge of the stabilizer.
Elevator pushrod
Rudder servo
