. Item code: BH163
DORNIER DO335
6. RUDDER INSTALLATION
Rudder
Rudder
RUDDER CONTROL HORN,
INSTALLATION
PUSHROD
Fuselage top side
Connector
Servo arm
Secure
Cut
Cut
A+B
glue
Epoxy
Rudder pushrod
Silicone Tube
Rudder
control horn
7. INSTALLING HORIZONTAL STABILIZER
1)
are installed the same way as the aileron
before (see page 5).
Elevator
Rudder c
way as the aileron before (see page 6).
ontrol horns, linkages
are installed the same
Rudders are installed the same way as the aileron
before (see page 5).
M2
Nut
800 mm Push rod
- - 2
- - - 2
- - 2
- - - - -
Horn
- - - - - 2
- - - - - - - 2
5mm Silicone Tube
- - - - - 1
Horn
Silicone Tube
Connector
- - - - - - - 1
400mm
Aluminium tube.
8mm
M2
Nut
800 mm Push rod
- - 2
- - - 2
- - 2
- - - - -
Horn
- - - - - 2
- - - - - 1
- - - - - 2
5mm Silicone Tube
1
- - -
Horn
Silicone Tube
Connector
- - - - - 1
9
Attach the aluminium tube
into the fuselage.
2)
Using a modeling knife, carefully remove the film
covering from the tail slots at the rear of the fuselage.
Make sure that you do not remove any wood from the
slots as this will affect the alignment of the tail.
Trim and remove the covering
from the tail slots.
Fuselage Top side
