14
. Item code: BH163
DORNIER DO335
11. INSTALLING THE RECEIVER, ESC AND BATTERY
1)
Plug the servo leads and the switch lead into the
receiver. You may want to plug an aileron extension into
the receiver to make plugging in the aileron servo lead
easier when you are installing the wing. Plug the battery
pack lead into the switch.
2)
Wrap the receiver and battery pack in the protective
foam to protect them from vibration. Use a rubber band
or masking tape to hold the foam in place.
3)
Position the battery pack and receiver behind the
fuel tank. Use two tie wraps to hold the battery and
receiver securely in place as pictures below.
Do not permanently secure the receiver and battery
until after balancing the model.
4)
Using a 2mm drill bit, drill a hole through the side of
the fuselage, near the receiver, for the antenna to exit.
Install two cable to the steering servo nose gear.
Fuselage top side
M2 Clevis
Nose gear s
ervo.
558 mm
Aluminium tube.
19mm
Locate the aluminium wing dihedral brace.
*** Test fit the aluminium tube dihedral brace into each
wing haft. The brace should slide in easily. If not, use
220 grit sand around the edges and ends of the brace
until it fits properly.
12. WING ATTACHMENT
Attach the aluminium tube into the fuselage.
ESC
ESC
Battery for motor
