15
YAK 54 -
ITEM CODE: BH48
.
Instruction Manual
2) When you a sure that everything is
aligned correctly, mix up a generous amount
of 30 Minute Epoxy. Apply a thin layer to the
top and bottom of the stabilizer mounting plat-
form sides in the fuselage. Slide the stabilizer
in place and realign. Double check all of your
mea-surements once more before the epoxy
cures. Hold the stabilizer in place with T-pins
or masking tape and remove any excess ep-
oxy using a paper towel and rubbing alcohol.
Epoxy glue.
Control horn of
elevator.
Drill a
hole 3mm
3) After the epoxy has fully cured, remove
the masking tape or T-pins used to hold the
stabilizer in place. Carefully inspect the glue
joints. Use more epoxy to fill in any gaps that
may exist that were not filled previously and
clean up the excess using a paper towel and
rubbing alcohol.
C/A glue
C/A glue
Epoxy glue.
Secure.
Elevator pushrod install as same as the way
of aileron pushrod.
165mm.
3x10mm.
ELEVATOR PUSHROD INSTALLATION.
