SBACH 342 Item code: BH174A
Instruction Manual
Set all scerws securely. If they come off during
flight you will lose control of your aircraft!
Warning!
1. Install the control horn into the aileron.
2. Locate the metal rod wire, screw the plastic link ball
onto the threaded end of the wire.
3. Plug the aileron servo into the receiver and center
the servo. Install the servo arm onto the servo. The
servo arm should be perpendicular to the servo and
point toward the middle of the wing.
4. Center the aileron and hold it in place using a
couple of pieces of masking tape. Adjust the
linkage until the aileron and the servo arm are
both centered and then tighten the nut against.
Remember use thread locking compound to
secure.
5. Repeat step 1 - step 4 for the second aileron
linkage.
INSTALLING THE AILERON LINKAGES
2.6 x 65mm
Aluminium ball
Aluminium ball
x2
10
Bottom View
Horn
3x35mm Socket Head
Cap Screw
- - - 2
- - - 2
- - - 2
2.6x65mm Push rod
- - 2
Ball link
- - - 4
3x12mm
Button
Head Cap Screw
- - - 2
3mm Lock nut
- - - 2
3x16mm Button
Head Cap Screw
- - - 2
- - - 2
3mm Flat Washer
