SBACH 342 Item code: BH174A
Instruction Manual
42
1. Completely charge your transmitter and receiver
batteries before your first day of flying.
2. Check every bolt and every glue joint in your
plane to ensure that everything is tight and well
bonded.
3. Double check the balance of the airplane
4. Check the control surface
5. Check the receiver antenna . It should be fully
extended and not coiled up inside the fuselage.
1. We highly recommend setting up a plane using
the control throws listed.
2. The control throws should be measured at the
widest point of each control surface.
3. Check to be sure the control surfaces move in
the correct directions.
Ailerons : 15 mm up
15 mm down
Elevator : 12 mm up
12 mm down
Rudder : 35 mm right 35 mm left
Ailerons : 40 mm up
40 mm down
Elevator : 55 mm up
55 mm down
Rudder : 60 mm right 60 mm left
HIGH RATE
LOW RATE
CG
Do not fly before confirming the
correct location of the CG. If the
CG is incorrect, you lose control
of your airplane which leads to
accidents.
In order to obtain the CG specified, reposition
the receiver and other equipment.
If not obtain the CG specified, add a weight and
adjust.
CONTROL THROWS
FLIGHT PREPARATION PRE FLIGHT CHECK
