18
GLASAIR -
Item code: BH74
.
Instruction Manual
Rudder servo install as same as method of
elevator servo. See picture below:
1
3. Mark the shape of the vertical on the left
and right side on the rudder using a felt-tip
pen.
1
4. Now, remove the rudder and using a
modeling knife, carefully cut just inside the
marked lines and remove the film of the rud-
der. Just as you did with the horizontal stabi-
lizer, make sure you only press hard enough
to cut the film, not the balsa rudder.
1
Also carefully remove the covering from
the horizontal fin as below the lines which
you drew as same picture below.
VERTICAL INSTALLATION.
Rudder servo
Remove covering.
90º
Vertical
Stabilizer.
Horizontal
Stabilizer.
Mark line.
Rudder
servo
Snap keeper
Elevator servo
Elevator servo
Elevator pushrod
1
2. Put the rudder into the fuselage as
same as picture below.
