B.A Eagle
Item code: BH158
Instruction Manual
32
3x12mm Tp Screw
INSTALLING THE SWITCH
1)
The switch should be mounted on the fuselage
side, opposite the muffler, close enough to the
receiver so the lead will reach. Use the face plate
of the switch cut out and locate the mounting holes.
2)
Cut out the switch hole using a modeling knife.
Use a 2mm drill bit and drill out the two mounting
holes through the fuselage side.
3)
Secure the switch in place using the two
machine screws provided with the radio system.
1)
Plug the servo leads and the switch lead into the
receiver. You may want to plug an aileron extension
into the receiver to make plugging in the aileron servo
lead easier when you are installing the wing. Plug the
battery pack lead into the switch.
2)
Wrap the receiver and battery pack in the protective
foam to protect them from vibration. Use a rubber
band or masking tape to hold the foam in place.
Do not permanently secure the receiver and
battery until after balancing the model.
INSTALLING THE SWITCH, RECEIVER AND BATTERY
<Fuselage top view>