SEA FURY
Item code: BH113-A
Instruction Manual
14
Locate the aluminium wing dihedral brace.
XII. WING ATTACHMENT
*** Test fit the aluminium tube dihedral brace into each
wing haft. The brace should slide in easily. If not, use
220 grit sand around the edges and ends of the brace
until it fits properly.
Attach the aluminium tube into the fuselage.
600 mm
Aluminium tube.
25mm.
Receiver
Battery of Receiver
Battery of engine
Push in
Insert the wing panel as pictures below.
Screw the wing panel in position.
Secure
Push in
Push in
Repeat the procedure for the other wing half.
XIII. INSTALLING COCKPIT
FUSELAGE
A/B Epoxy glue.
Please see pictures below.
2)
Wrap the receiver and battery pack in the protec-
tive foam to protect them from vibration. Use a rubber
band or masking tape to hold the foam in place.
3)
Position the battery pack and receiver behind
the fuel tank. Use two tie wraps to hold the battery and
receiver securely in place as pictures below.
Do not permanently secure the receiver and battery
until after balancing the model.
4)
Using a 2mm drill bit, drill a hole through the side
of the fuselage, near the receiver, for the antenna to exit.
