SEA FURY
Item code: BH113-A
Instruction Manual
15
A/B Epoxy glue.
Push in
Push in
Open and
Close
Position the canopy so the rear frame on the canopy is
aligned with the rear edge of the cockpit opening. Use
canopy glue to secure the canopy to the canopy hatch.
Use low-tack tape to hold the canopy in position until
the glue fully cures. Wrap the tape completely around
the canopy hatch, as the tape does not stick well to
the covering. We used balsa sticks to hold the lower
edges of the canopy tightly against the canopy hatch.
Installing the fuselage hatch as same as picture below.
Install the spinner backplate, propeller and spinner
cone. The spinner cone is held in place using two
3mm x 15 mm machine screws.
XIV. INSTALLING THE SPINNER
