22
EDGE -
Item code: BH69-A
.
Instruction Manual
1. Cut out the switch hole using a modeling
knife. Use a 2mm drill bit and drill out the two
mounting holes through the fuselage side.
2. Secure the switch in place using the
two machine screws provided with the radio
system.
3. Position the battery pack and receiver
behind the fuel tank. Use the two light plywood
pieces, placed over the battery and receiver
and glue to the fuselage sides to hold the bat-
tery and receiver securely in place. Use 15mm
triangle pieces glued between the fuselage
sides and the plywood pieces to reinforce the
joints.
Do not permanently secure the receiver and
battery until after balancing the model.
4. Using a 2mm drill bit, drill a hole through
the side of the fuselage, near the receiver, for
the antenna to exit.
1.Locate the aluminium wing dihedral
brace.
Battery
Receiver
Switch.
25 mm
566 mm
Bottom side.
Secure.
INSTALLING THE SWITCH.
WING ATTACHMENT.
1. Plug the servo leads and the switch
lead into the receiver. You may want to plug
an aileron extension into the receiver to make
plugging in the aileron servo lead easier
when you are installing the wing . Plug the
battery pack lead into the switch.
2. Wrap the receiver and battery pack in
the protective foam to protect them from vi-
bration. Use a rubber band or masking tape to
hold the foam in place.
INSTALLING THE RECEIVER AND BATTERY.
