19
EDGE -
Item code: BH69-A
.
Instruction Manual
1. Set the tail wheel assembly in place
on the plywood plate. The pivot point of the
tail wheel wire should be even with the rud-
der hinge line and the tail wheel bracket should
be centered on the plywood plate.
2. Using a pen, mark the locations of the
two mounting screws. Remove the tail wheel
bracket and drill 1mm pilot holes at the loca-
tions marked.
MOUNTING THE TAIL WHEEL
BRACKET.
3. Secure the tail wheel bracket in place
using three 3mm x 12mm wood screws. Be
careful not to overtighten the screws.
Secure
Mark point.
Drill a hole
2 mm
R u d d e r
pushrod.
Snap keeper
3mm x 12mm
R u d d e r
pushrod
Bottom side
