Black Diamond Equipment TC1024DCA, Instructions Manual

Page: 7 / 19

(
9) INSTALLATION
Positioning and installation
●
The machine has been placed in selected positions, marked expansion screws, tighten the mounting
steadily.
●
All electrical installation must be performed by qualified person.
●
Before installation and connection, check if the power voltage of the machine on the nameplate
matches the labe, which also cable with a protective grid must be installed and there is a good
ground cover protection and automatically install air leakage switch on the main power source, Drain
power set at within 50mA / s .
●
Check the motor rotation direction (this check only for machines equipped with three-phase motors).
●
Depress the turntable forward / reverse control pedal wheel should rotate clockwise, counterclock-
wise rotary dial, you can swap any two at the switch
●
Phase cable connector, if user does not follow the above instruction, ,factory will not be responsible
to any damage caused by above instructions.
Note: If the machine does not have the power plug, the user must install a self-consistent voltage and
machine power plug.
●
·The machine requires air pressure with range 7-10 bar (100-140 psi) to meet the guaranteed use of
the machine, if less than 7bar (100psi),bead breaker shovel may not be working as usual.
●
Must use blow piper before air hose newly installed in order to avoid damage from the new pipe to
the machine. Users has to regularly drain he air compressor.
●
Connect the air compressor and filter system on the machine. After the connection , user should
check on the lubricator pressure gauge whether the requirements in the pressure setting is met, if not
please check the tubing or air compressor if it is defective.