Page 4
Page 5
1.
Unpack unit and save all packaging material for storage when season is over.
2. Select the proper location as noted in above instructions.
3. Plug the cord into a compatible extension cord if needed as noted in above
electrical instructions.
4. Once plugged into powered outlet, the device is active. UV lights should
illuminate and zapper is ready for use.
5. If using removable bottom tray, make sure to clean the tray often of dead insects.
6. If using over natural setting, remove tray permanently (see instructions below)
to allow zapped insects to fall freely through onto the ground. This will eliminate
the need to clear away dead insects that can build up inside the tray.
7. If zapping grid shows signs of accumulation of dead insects on the live electrified
grid, occasional cleaning of wire grid may be required (see further instructions
detailing this process).
8. It is recommended that this unit be placed into use from early Spring until late
Fall for best results.
9. The device is designed to withstand moderate rain. If severe weather is expected,
it is recommended to remove this device and store indoors until severe weather
has passed.
10. Unplug device when not in use.
REMOVING & CLEANING BOTTOM TRAY:
MAINTENANCE
Removal of bottom tray when unit is placed in yard eliminates the need to empty bottom
tray for insect removal.
If bottom tray is intended to contain dead insects from falling to ground, tray should be
emptied frequently. Use caution and use gloves when opening tray as some dead insects
potentially may fall out of tray upon removal.
HOW TO USE:
The BDPC912 Electronic Bug Zapper exterior housing does not require cleaning. Periodic
rainfall will clean the exterior. Do not attempt to clean the housing with water or spray or
any other liquids.
• In areas with large insect populations, electric
grid may begin to accumulate dead insects on
the grid that can affect the function of the device.
To ensure effective use of this device periodic
cleaning of electric grid with included brush may
be necessary.
• Rate of cleaning depends on insect population in
your area.
1. Unplug the device and remove unit from hanging position and allow it to sit for three
hours to allow all electricity in unit to disperse.
2. Access grid through the open slots in grill as shown using included cleaning brush and
gently brush away dead insects so they fall down into the lower tray for removal.
3. Never use water to clean the unit as this can cause damage to the electronics.
4. Use care and make sure not to move the metal electric grid.
5. Return unit to hanging position and plug back in
ELECTRIC GRID CLEANING:
WARNING:
Always unplug your Bug Zapper before cleaning to
avoid electric shock. When cleaning electric grid, only
use included cleaning brush to avoid any risk of shock
or injury. Ignoring this warning may result in death or
injury.
To remove
tray:
Slide out as shown
Summary of Contents for BDPC912
Page 7: ......
