7
ENGLISH
(Original instructions)
These include:
u
Injuries caused by touching any mov-
ing parts.
u
Injuries caused by touching any hot
parts.
u
Injuries caused when changing any
parts or accessories.
u
Injuries caused by prolonged use of
the appliance. When using any appli-
ance for prolonged periods ensure you
take regular breaks.
Electrical safety
The appliance is designed for use with
12V negative ground vehicle battery
systems.
Warning!
The cigarette lighter connec-
tor is fitted with a non-serviceable safety
fuse. The fuse may operate in the event
of a fault. If this occurs the fuse must be
replaced together with the connector and
cable by the manufacturer or an author-
ised Black and Decker Service Centre in
order to avoid a hazard.
Warning!
Do not operate the appliance
with systems which have positive ground
or a different voltage.
Features
This appliance includes some or all of the following features.
1. On / Off switch
2. Nozzle rotate button
3. Bowl release button
4. Nozzle
5. Crevice tool
6. Cigarette lighter connector
7. Brush tool
8. Removable dust bowl
9. Dust bowl door release
10. Right angle brush tool
11. Hose
12. Hose connector
Assembly
Adjusting the Nozzle (fig. A, B,)
u
The nozzle (4) is stored under the appliance. To adjust
for use, press the nozzle rotate button (2) and rotate the
nozzle to the required position.
u
Release the nozzle rotate button (2) to lock the nozzle (4)
in position.
u
The dust nozzle (4) can be extended by pulling the crevice
tool (5) until it locks into position.
u
The crevice tool can be retracted by pressing the button
(13) and pushing the crevice tool (5) back into the nozzle.
u
The nozzle (4) should be returned to the storage position
under the appliance after use.
Using the built in brush (fig. C)
u
The built in brush (7) is located beneath the nozzle (4) and
can be rotated and locked into position for use.
Fitting the accessories (fig D)
The appliance is supplied with the following accessories:
u
A right angle brush tool (10 ) for upholstery
u
An extension hose (11)
u
A hose connector (12)
To fit an accessory, proceed as follows:
u
Fit the hose connector (12) onto the nose of the appliance
and attach one end of the hose (12) to the connector.
u
Attach the right-angled brush tool (10) to the other end of
the hose.
u
When not in use, the accessories can be stored in the
storage bag (Provided).
Use
Connecting to the vehicle’s power
supply
u
Make sure that the appliance is switched off.
u
Remove the cigarette lighter from it’s socket.
u
Plug the connector (6) into the cigarette lighter socket.
Switching on and off (fig. E)
u
To switch on, slide the on/off switch (1) forward.
u
To switch off, slide the on/off switch back.
The appliance can be used for periods of up to 30 minutes
without noticeably affecting the power of a normally charged
car battery in good condition.
