Page 18
SET UP & USE
OPERATING INSTRUCTIONS
The unit can be controlled by the unit
control alone or with the remote.
NOTE:
The outline of the operation panel
is based on typical model, the
function is the same with your air
conditioner while there may be some
slight differences in appearance.
TO TURN UNIT ON OR OFF:
Press ON/OFF button to turn unit on or off.
NOTE:
The unit will initiate automatically
the Energy Saver function under
Cool, Dry and Auto modes.
TO CHANGE TEMPERATURE
SETTING:
Press UP/DOWN button to change
temperature setting.
NOTE:
Press or hold either UP or
DOWN button until the desired
temperature is shown on the
display.
This temperature will be automatically
read the actual room temperature, see To
Operate on Fan Only section.
SLEEP FEATURE:
Press Sleep button to initiate the
sleep mode. In this mode the selected
30 minutes after the mode is selected. The
temperature will then increase (cooling) by
30 minutes. This new temperature will
be maintained for 6 or 7 hours before
it returns to the originally selected
temperature. This ends the Sleep mode
and the unit will continue to operate as
originally programmed. The Sleep mode
program can be cancelled at any time
during operation by pressing the Sleep
button again.
TO ADJUST FAN SPEEDS:
Press Fan button to select the Fan Speed
in four steps-Auto, Low, Med or High. Each
time the button is pressed, the fan speed
mode is shifted.
CHECK FILTER FEATURE:
feature. This feature is a reminder to clean
The LED(light) will illuminate after 250
hours of operation. To reset after leaning
the light will go off.
ENERGY SAVER FEATURE:
Press Energy saver button to initiate this
function. This function is available on
COOL, DRY, AUTO (only AUTO-COOLING
and AUTO-FAN) modes. The fan will
continue to run for 3 minutes after the
compressor shuts off. The fan then cycles
on for 2 minutes at 10 minute intervals until
the room temperature is above the set
temperature, at which time the compressor
turns back on and Cooling Starts.
TO SELECT THE OPERATING
MODE:
To choose operating mode, press Mode
button. Each time you press the button, a
mode is selected in a sequence that goes
from Auto, Cool, Dry and Fan. The indicator
light beside will be illuminated and
remained on once the mode is selected.
The unit will initiate automatically the
Energy Saver function under Cool, Dry,
Auto (only Auto-Cooling and Auto-Fan)
modes.
TO OPERATE ON COOL MODE:
Choose Cool Mode to set the cooling
function. Use the Up and Down buttons
to choose the desired temperature. When
Cool Mode is selected, the fan speed can
be adjusted by pressing the fan button.
