Black Box SWI069A, Manual

Page: 32 / 37

29
CHAPTER 5: Operation
5.4 The Default Command
The Default Command (/D) sets all plugs to their default On/Off status. The
default status is set using the Plug Parameters menus described in
Section 4.5 .
Plugs will be set to these defaults when /D is invoked, or after a power
interruption. To set all plugs to defaults, type
/D
and press [Enter] .
NOTE
When User Mode is active, this command will only be applied to plugs
owned by the User’s password. The command will not be applied to
plugs owned by other passwords.
When the System Mode is active, this command will be applied to all
eight plugs.
This command will always be applied to all owned plugs. It cannot be
applied to only one plug.
5.5 Other Commands
5.5.1 L
OG
I
N AS
D
IFFERENT
U
SER
The /R command is used to re-log-in using a different password. When invoked,
the Network Power Switch will display the password prompt, allowing you to enter
a different password in order to access other ports or command functions. The /R
command can be used to switch from User Mode to System Mode.
Note that although this command is not listed in the User Help Screen, it is
available in both System Mode and User Mode. To log in as a different user, type
/R
, press [Enter] , and then key in a different valid password at the prompt.
5.5.2 R
ESET
N
ETWORK
P
ORT
The /T command is used to reset the Network Power Switch Network Port. When
the /T command is invoked, the Network Power Switch will re-initialize its network
card. The /T command is not available in User Mode. To reset the Network Port,
type
/T
and press [Enter] .
5.5.3 E
XIT
/D
ISCONNECT
To exit from the Network Power Switch Command Mode and discontinue
connection to the unit, type
/X
, and press [Enter] . The Network Power Switch will
display the “DISCONNECT” message.