20
NETWORK POWER SWITCH
commands. For example, if the Disconnect Timeout is set at 5 minutes, the
Network Power Switch will automatically disconnect after 5 minutes of
inactivity. Type
7
, press
[Enter]
, and follow the instructions in the submenu.
8.
Plug Confirmation:
Enables/Disables the plug confirmation feature. When
enabled, the Network Power Switch will display a prompt before performing
Boot/On/Off operations, and will also display the System Status screen after
these commands are successfully completed. Type
8
, press
[Enter]
, and follow
the instructions in the submenu.
A.
Default Parameters:
When selected, the Network Power Switch will first
display the “Default Parameters?” prompt. If
Y
is entered, the Switch will then
be reset to the default parameters specified by the Options Switches. Note that
when this command is invoked, all user-selected parameters, including port
names and passwords, will be lost.
B.
Cycle On/Off Test
(for diagnostic purposes only): When this item is selected,
the Network Power Switch will display the “Start Cycle Test?” prompt. If
Y
is
entered, the Switch will begin the Cycle On/Off Test; all plugs will first be
switched off, and then each plug will be switched On and Off, one at a time.
To terminate the test, press
[Esc]
.
After defining the General Parameters, press
[Esc]
to return to the Network Power
Switch command prompt.
4.5 Plug Parameters
The Plug Parameters menus are used to assign names and select parameters for
each individual switched outlet. There is a separate Plug Parameters menu for each
outlet. Note that the Plug Parameters menus are not available in User Mode.
In addition to selecting parameters for each outlet, the Plug Parameters menus
also determine which outlets will be controlled or “owned” by each User Password.
A separate User Password can be assigned to each plug, or the same password can
be assigned to several plugs. When a User Password is entered, you will have access
to all plugs owned by that password.
To access the Plug Parameters menus from the NPS> prompt, type
/P n
and press
[Enter]
. “
n
” is the number or name of one of the eight switched outlets. The Plug
Parameters menu (Figure 4) offers the following options:
Summary of Contents for SWI069A
Page 3: ......
