39
CHAPTER 8: Command Line Utility
8. Command Line Utility
The ApconCmd.exe Windows command line utility enables you to set switch
parameters by typing commands at the Windows DOS prompt. These commands
may also be included in batch files or may be assigned to icons on the Windows
desktop. The ApconCmd.exe utility is automatically copied to your disk drive when
you install the control software and may be found in the same subdirectory as the
control software.
Use:
apconcmd [
/?
] [
/i
<IP Address>] [
/c
<Com Port>]
[
/b
<Baud Rate>][
/n
<Device Number>] [
/v
][/
d
][/
p
][/
0
]
[[
/s
]<Port Settings>[
/t
<Termination>][
/h
<holdoff>] [
/x
]
[[
/g ##
][
/j ##
][
/l ####
][
/u ####
][
/w
<command>][
/r
<command>]
or:
apconcmd
/f
<IP Address, IP Address>[/n <Device Number,<Device Number>>]
Where:
/?
<this message>.
/i
<IP Address> = The IP address of the network-enabled 10/100 Physical Layer
Ethernet Switch (IP Address uses #.#.#.# decimal form).
/c
<Com Port> = The number of the Com port to use (1–8; the default is 1).
/b
<Baud Rate> = The baud rate for the Com port (2400, 9600, 19200; the default
is 9600).
/n
<Device Number> = The device number of the 10/100 Physical Layer Ethernet
Switch to change (1–32; the default is 1).
/v
= Show 10/100 Physical Layer Ethernet Switch version information.
/d
= Display current port settings. Returns formatted string.
/p
= Display switch settings in row/column format (A01B02…).
/0
= Clear all port and termination settings.
[
/s
]<Port Settings> = Port settings string to send to a switch. Use -
s ?
to view
settings options.
Summary of Contents for SW595A
Page 3: ......