724-746-5500 | blackbox.com
Page 20
Chapter 7: Console Commands (SW1041A Only)
GET MANAGER N
Display SNMP manager N (1-16) IP address.
GET MANAGER
Display all SNMP manager IP addresses.
PING X.X.X.X
Causes the A/B Switch to issue a single ICMP echo request packet to the designated IP address. If a response is received, the A/B
Switch will display the message “Reply from X.X.X.X”. If no response is received within 5 seconds, the A/B Switch will display the
message “Request timed out.”
SAVE
Save settings for next startup. All settings are stored in NV memory and restored upon power on. Any change will not become
permanent until a SAVE and RESET operation sequence is performed.
RESET
Causes a network system reboot and reloads all parameters from stored settings.
NOTE: You will lose your connection and have to log in again if giving this command from a telnet or web interface session.
SET DEFAULTS
Causes the A/B Switch configuration parameters to be restored to the factory settings. Any changes to the settings will not
become permanent until a SAVE and RESET operation sequence is performed.
