724-746-5500 | blackbox.com
Page 16
Chapter 7: Console Commands (SW1041A Only)
SET SYSTEM A[B]
Sets the system to position A or B.
SET IPADDRESS X.X.X.X
GET IPADDRESS
Set or display the current IP address of the network module. Any change will not become permanent until a SAVE and RESET
operation sequence is performed.
SET SUBNETMASK X.X.X.X
GET SUBNETMASK
Set or display the current subnet mask of the network module. Any change will not become permanent until a SAVE and RESET
operation sequence is performed.
SET GATEWAY X.X.X.X
GET GATEWAY
Set or display the current gateway IP address of the network module Any change will not become permanent until a SAVE and
RESET operation sequence is performed.
SET PINGREPLY ON[OFF]
GET PINGREPLY
Set or display whether or not the A/B Switch will respond to incoming PINGs (ICMP echo requests). Any change will not become
permanent until a SAVE operation is performed.
SET SNMPENABLE ON[OFF]
GET SNMPENABLE
Set or display whether or not the SNMP interface on the A/B Switch is enabled. Any change will not become permanent until a
SAVE operation is performed.
SET READCOMMUNITYNAME string
GET READCOMMUNITYNAME
SET WRITECOMMUNITYNAME string
GET WRITECOMMUNITYNAME
Set or display the current read or write community name as specified. Note that in general these are case sensitive fields. Any
change will not become permanent until a SAVE and RESET operation sequence is performed.
SET WEBENABLE ON[OFF]
GET WEBENABLE
Set or display the current state of web based access. The network module will not accept any HTTP requests when web enable is
off. Any change will not become permanent until a SAVE and RESET operation sequence is performed.
