724-746-5500 | blackbox.com
Page 17
Chapter 7: Console Commands (SW1041A Only)
SET WEBPASSWORD string
GET WEBPASSWORD
Set or display the current web password. Note that this is a case sensitive field. Any change will not become permanent until a
SAVE and RESET operation sequence is performed.
SET WEBTIMEOUT seconds
GET WEBTIMEOUT
Set or display the current web timeout in seconds. After a period of inactivity of this many seconds, the network module will
request a login. Note that the web timeout cannot be disabled any change will not become permanent until a SAVE and RESET
operation sequence is performed.
SET WEBPORT N
GET WEBPORT
Set or display the current web port number. Changing the web port number from the default can be used to provide an
additional level of security. Any change will not become permanent until a SAVE and RESET operation sequence is performed.
SET TELNETENABLE ON[OFF]
GET TELNETENABLE
Set or display the current state of telnet based access. The network module will not accept any telnet requests when telnet enable
is off. Any change will not become permanent until a SAVE and RESET operation sequence is performed.
SET TELNETPASSWORD string
GET TELNETPASSWORD
Set or display the current telnet password. Note that this is a case sensitive field. Any change will not become permanent until a
SAVE and RESET operation sequence is performed.
SET TELNETTIMEOUT seconds
GET TELNETTIMEOUT
Set or display the current telnet timeout in seconds. After a period of inactivity of this many seconds, the network module will
disconnect any current telnet session. Note that the telnet timeout cannot be disabled, it can however, be set arbitrarily large. Any
change will not become permanent until a SAVE and RESET operation sequence is performed.
SET TELNETPORT N
GET TELNETPORT
Set or display the current telnet port number. Changing the telnet port number from the default can be used to provide an
additional level of security. Any change will not become permanent until a SAVE and RESET operation sequence is performed.