Black Box ServSwitch SW721AE-R2, User Manual

Page: 25 / 48

23
CHAPTER 4: Operation
Table 4-2 (continued). The ServSwitch’s keyboard commands.
Command Keystroke Sequence Description
Switch to the
[CTRL] -
Switches to the previous port in
Previous Port sequence.
Scan ON
[CTRL] S
Turns Scan mode ON, causing the
ServSwitch to start scanning
sequentially from the current port
through the remaining ports and then
begin again at Port 1.
Scan OFF
[CTRL] X
Turns Scan mode OFF (the port being
scanned at the time the command is
entered is given access to the shared
monitor, keyboard, and mouse).
NOTE
Scan can also be stopped by entering a Select Port command.
Keep Settings
[CTRL] K
Enter this command after you enter any
of the following seven commands (it
saves new settings to nonvolatile
memory).
Set Scan-Delay
[CTRL] T xx [ENTER]
Sets the time, in seconds, that the
Time ( xx =delay in seconds ServSwitch will pause at each port
from 1 to 15) when scanning.
Set Screen
[CTRL] V xxx
Sets the time of inactivity, in seconds,
Saver’s Delay
[ENTER]
after which the ServSwitch will blank
Time ( xxx =delay in seconds) the shared monitor’s screen. (The
monitor is reactivated when the PS/2
mouse is moved or any key on the
shared keyboard is pressed.)