13
CHAPTER 3: Installation
5. Plug your SDSL cable into the RJ-45 jack marked
“SDSL” on the Unit’s rear panel. (This jack is
designed to accept either RJ-45 or RJ-11 plugs. The
SDSL cable should be 22 to 26 AWG telephone
cable with Ring and Tip on the center two pins: If
it has RJ-45 connectors, Ring should be on Pin 4
and Tip should be on Pin 5. If it uses RJ-11
connectors, Ring should be on Pin 2 and Tip
should be on Pin 3.)
6. Perform steps 3 through 5 at the other site with
your Subscriber Unit. Please note that the LED
operation described in Step 4, above, does not
apply to the Subscriber Unit. The only LED that
should light is the Power LED.
7. Once the SDSL cable is connected to both the
Provider and Subscriber Units, the Connection
LED on each Unit should begin pulsing steadily
(once per second) to indicate that the SDSL link
has been established and is operating. When the
Connection LED starts doing this, the Link, Tx,
and Rx LEDs should go dark until you plug in the
Ethernet cable and an Ethernet connection is
established.
