Chapter 2 Installation and Setup
2-6
Configuring Standalone Unit
Connecting the AC Power
AC power should be supplied to the MT1100A, MT1101A, MT1102A units
through the 1.5m (5 ft) standard power cable terminated with a standard 3-prong
plug. The cable is provided with the unit.
Before connecting power to the unit, verify that the socket outlet is provided
with a protective ground contact. If you are using an extension cord (power
cable) make sure it is grounded as well
Interrupting the protective (grounding) conductor (inside or outside the unit),
or disconnecting the protective ground terminal can make this unit dangerous.
Make sure that only fuses of the required rating (0.250A, 250V) are used for
replacement. Do not use repaired fuses or short-circuit the fuse holder. Always
disconnect the mains cable before removing or replacing the fuse. If there is a
chance that the fuse protection has been damaged, make the unit inoperative.
To connect AC power:
1. Connect the power cable to the power connector on the rear panel.
2. Plug the power cable to the mains outlet.
The unit turns on automatically upon connection to the mains.
Connecting the DC Power
To connect DC power:
•
Refer to the DC power supply connection supplement.
Warning
