17
CHAPTER 3: Installation
3. Installation
This chapter shows you how to install the G.703 Codirectional Converter.
After you complete the installation, refer to
Chapter 4
for operating
information.
The G.703 Codirectional Converter is designed for placement on a shelf or
bench, and comes completely assembled. With the rackmount-adapter kit,
you can also install it in a 19-inch rack.
3.1 Unpacking
Unpack the equipment this way:
• Carefully take the G.703 Codirectional Converter out of the box it came
in and place the Converter on a clean surface.
• Inspect the unit for damage. Immediately report any damage you find
to your carrier and supplier.
3.2 Site Requirements
The G.703 Codirectional Converter should be installed within 5 feet (1.5 m)
of a grounded AC outlet capable of furnishing 230 or 115 volts. It must be
situated within half a mile (800 m) of the PCM equipment.
Make sure that there is at least 4 inches (10 cm) of clearance behind the
G.703 Codirectional Converter for signal lines and interface cables.
3.3 Setting Jumpers
3.3.1 O
VERVIEW
Prior to installing the G.703 Codirectional Converter, determine its
configuration in the data system and set its jumpers accordingly. Refer to
Table 3-1. The diagrams in
Chapter 2
can help you identify the required
jumper selection. Jumper locations on the printed circuit board are shown in
Figure 3-1. Read the instructions in
Section 3.3.2
before making any changes.
