22
G.703 CODIRECTIONAL CONVERTER
3.4.3 I
NSTALLING
T
WO
U
NITS IN A
19-I
NCH
R
ACK
The adapter kit includes two adapter brackets and various hardware for
attaching two Converters side by side in a 19-inch rack. Refer to Figure 3-3
when you perform the following procedure:
1. Remove the cover (item #1 in Figure 3-3) from the unit intended to
be on the right-hand side.
2. Position one of the two “U” brackets supplied with the kit (items #2)
in the slots inside of the unit’s inner left-hand wall, and align the
bracket’s holes with the holes on the wall.
3. Insert flat washers (items #3A) over one pair of long screws (items #3B)
and screw the screws through the U bracket (item #2) into the holes on
the wall.
4. Repeat steps 2 and 3 above for the other U bracket.
5. Hold the second unit close to the left wall of the opened unit and,
using a screwdriver, drive the four long screws (items #3B) until their
ends emerge from the first unit’s left wall and engage the holes on the
right side of the second unit. Tighten each screw one turn at a time—
do not tighten one screw completely before you start to tighten any of
the others. Continue to tighten the screws until their heads rest against
the U brackets (items #2) and the two Converter units are in contact.
6. Reinstall the cover (item #1) of the first unit (the unit on the right).
7. Fasten one of the two adapter brackets supplied with the kit (items #7A)
to the side wall of each unit using the four short screws (items #7B) and
four flat washers (items #7C) that are also included.
8. You can now use four screws (
not
supplied with the kit), two on each
side, to fasten the assembled units to the side rails of the 19-inch rack.
