35
CHAPTER 3: Installation
3.4 Installing Interface Modules
As shown in
Figure 3-5
, the interface modules are held in place by two rails and are
fastened by two captive screws to the rear panel.
• To remove a module, release the two captive screws and pull the module out.
• To install a module, carefully insert the module board into the rails and push
in to mate the module connector, until resistance is felt. Tighten the two
module screws.
Figure 3-5. Installation of interface modules.
Summary of Contents for ME260A
Page 48: ...NOTES...
Page 49: ...NOTES...
