103
5.0 Hayes Emulation Mode
Table 5-1(continued). Hayes Compatible Commands.
COMMAND
FUNCTION/EXPLANATION
\N
V.42 Mode *
1
\N0
Disables error correction.
\N1
Enables mandatory mode for error correction.
\N2
Disables error correction.
\N3
Enables automatic mode for error correction.
\P
V.42 Protocol *
1
\P0
Selects LAPM protocol only.
\P1
Selects MNP protocol only.
\P2
Selects LAPM/MNP protocol (MNP as alternate).
\Q
V.42 Flow Control *
1
Two parameters may be used
(e.g., \Q0,1; \Q3,2 , etc.). First parameter specifies DCE-
DTE flow; second (optional) specifies DTE-DCE flow control.
0
None (no flow control).
1
CTS on/off or RTS on/off (CTS for DCE-DTE flow
control, RTS for DTE-DCE).
2
DC1/DC2 flow control.
3
DC1/DC3 flow control (default for DCE-DTE and
DTE-DCE).
\S
View Status Of V.42-Related Configuration
No parameters.
\T
Load Inactivity Timer
\T0
Disables inactivity timer.
\Tn
Sets inactivity timer to n minutes (where n = 0 to 60).
\V
V.42 Result Codes
1
\V0
Activates regular V.42 result codes.
\V1
Activates extended V.42 result codes.
\X
V.42 Pass-Through Flow Control *
1
\X0
Enables pass-through flow control.
\X1
Disables pass-through flow control.
NOTE: DTE speed and parity are set automatically. Auto-answer is enabled or disabled by S register S0.
1
Option can be changed only when Modem is off-line.Default settings (where applicable) are in
bold face
.
* If user profile 1 is active, options are controlled (for Hayes mode operation) by given commands or
Summary Setup. Do not change via front panel (except via Summary Setup).
