Ending the Session
Be sure to press E to end a serial port or Telnet/HyperTerminal session, before
disconnecting the cable. This will stop the continuous stream of data to the serial
port.
Rebooting the Unit
To reboot the IE Managed Miniature Media Converter, type
reboot
.
Enabling/Disabling DHCP
To toggle DHCP on the IE Managed Miniature Media Converter between enable and
disable, press
D
.
Additional Device-Specific Commands
The IE Managed Miniature Media Converter also includes the following device-
specific options.
To access these options, perform the following:
1.
Press the
space bar
when in the Command List section of the Main
Configuration screen (serial configuration/Telnet session).
2.
Type the name of the action (shown below) and press
Enter
.
•
port -
Displays and changes port settings, such as duplex status and speed.
•
unit -
Displays and changes the unit’s settings, such as flow control, FiberAlert, and
loopback.
•
config -
Allows VLAN and transparency mode configurations.
•
reboot -
Reboots the unit and clears all internal counters.
•
cleandb -
Reboots the unit with a clean database. This removes all information
from the database and sets the unit to factory defaults.
•
ifStats -
Displays Ethernet statistics
•
rmStats -
Displays RMON statistics
•
version -
Displays the unit’s serial number and build date
•
security -
Allows ARP request configuration. This setting is only for very unique
configurations and should not be adjusted.
•
download -
Downloads firmware via the TFTP protocol
•
sysname -
Allows modification of the units system name, not to exceed 16
characters.
•
accounts -
Allows the addition of new users.
16
Summary of Contents for LMM101A
Page 37: ...Notes 31...
