22
LINESHARE MASTER-4, LINESHARE RACK
The Lineshare Master-4 then
enters the programming mode,
and you will hear a busy tone or
a repeating message from the
intercept operator.
Ignore the activity on the phone
line and continue with your
changes. If the phone company
resets your line and you receive a
busy tone, re-enter * #, or hang
up the phone for 10 seconds, re-
enter programming and
continue with your changes. If a
reset occurs in the middle of a
command (before receiving
confirmation tones), re-enter
that command only. Any
previous entries have been
saved.
5. To exit the programming mode
after completing your changes,
press the # key.
The Lineshare Master-4
produces three quick beeps and
exits the programming mode.
If you adjust any of the timing
registers, be sure to properly
calculate the amount of time
before the Lineshare Master-4
drops the line (about five
seconds before the calling device
connects to it). See
Section 5.2,
Calculating the Timing
Parameters
, for more
information.
6. After you complete
programming changes, remove
the tone phone from the
modem patch panel, and replace
it with the modem previously
connected.
