Black Box IT1000, Manual

Page: 17 / 40

15
IT1000 Basic Rate ISDN Tester
TECHNICAL: 0870 90 10 750
The correct indicator combinations for all stand alone tests are shown below :
Test Function B1 B2 Pass/Fail
Data Call D Channel ON OFF OFF
Data Call B Channel OFF ON OFF
Outbound Voice Call ON ON OFF
Inbound Voice Answering OFF OFF ON
Email logs to remote user ON OFF ON
Line Voltage OFF ON ON
3.2.4 Running the test
When the required test is indicated, the MODE / RUN button is then pressed and held for 3 seconds
to start the test cycle.
What happens next depends on the test selected. For example, the voice test will call a specified
number and deliver a message saying that that test was successful. If a data test was selected, the
unit will attempt to set up a data circuit between the B1 and B2 channels.
A full specification of the default tests as pre-configured from the factory are given in Chapter 4.
3.2.5 Test Results
Regardless of the test selected, the result is displayed on the Pass / Fail indicator together with a
musical tone from the internal speaker as follows :
•
A GREEN indicator together with a rising tone indicates that all the programmed tests were
performed satisfactorily.
•
A RED indicator together a descending musical tone indicates that one or more of the
programmed tests failed. A note is written to the error log which can be examined via the
DTE port (see 2.3 below)
3.2.6 Turning the Unit Off
Your IT1000 is equipped with an ‘auto power off’ feature which will switch the unit off to conserve
battery power whenever there has been no activity for a certain time. The power off delay is user
configurable and can be changed in IT1000 Explorer
Options >Configure IT1000 menu.