Chapter 3: Installation
724-746-5500 | blackbox.com
Page 21
3.2.6 Transmitter power connection
Each Wizard DP Extender unit is supplied with a 20W power adaptor. There is no on/off switch on the unit, so operation begins
as soon as a power adaptor is connected.
3.2.6.1 To connect the power supply
1 Attach the output lead from the power adaptor to the
5V
socket on the rear panel of the unit.
Note: Both the unit and its power supply generate heat when in operation and will become warm to the touch. Do not enclose
them or place them in locations where air cannot circulate to cool the equipment. Do not operate the equipment in ambient tem-
peratures exceeding 40 degrees Centigrade. Do not place the products in contact with equipment whose surface temperature
exceeds 40 degrees Centigrade.
2 Connect the IEC connector of the supplied country-specific power lead to the socket of the power adaptor.
3 Connect the power lead to a nearby mains supply socket.
