ENGLISH
ENGLISH
MAINTENANCE & CARE
16
17
18
17 HANDLE REMOVAL
Turn off water supplies and relieve pressure before working on your faucet!
To
remove Handles (
17A
), the Spout Body (
17B
) must be removed. From underneath sink,
remove Square Washer (
17C
) and Locknut (
17D
) from Spout Shank (
17E
). Detach
Decorative Button (
17F
), unscrew Fastener (
17G
) from Handles (
17A
). Lift Spout Body
(
17B
) from sink and remove Handles (
17A
) from Spout Bridge (
17H
).
18 VALVE CARTRIDGE REMOVAL
Turn off water supplies and relieve pressure before working on your faucet!
Remove Spout Body and Handles (
see step 17
). From underneath sink, remove Clip
(
18A
), Inlet Connector (
18B
), Square Washer (
18C
) and Locknut (
18D
) from Valve
Shanks (
18E
). Remove Valve Body (
18F
) from Flange (
18G
). Remove Stem Extender
(
18H
), unscrew Retainer Nut (
18J
) by turning it counter-clockwise and lift out Cartridge
Assembly (
18K
) and inspect. Replace parts as necessary.
CAUTION: Maintenance
DISASSEMBLY
1.
Replacement parts may be available at the store where you purchased
your faucet.
2.
When replacement parts are not available, please write or call Price
Pfister Consumer Service.
3.
Always turn off water and relieve pressure before working on your
faucet.
NOTE: Trim Care
Cleaning Instructions:
For all Handles and decorative finishes, use only a soft damp
cloth to clean and shine. Use of polish, detergents, abrasive
cleaners, organic solvents or acid may cause damage.
Use of
other than a soft damp cloth will nullify our warranty!
Special Trim:
Trim products which contain Porcelain or other similar
substance are not acceptable for public areas or Commercial
use. Installation of Said Trim is at Users Risk!
1–800–PFAUCET (1–800–732–8238)
For Toll-Free Pfaucet information call
1–800–PFAUCET (1–800–732–8238)
or visit www.pricepfister.com
• Installation Support
• Care and Warranty Information
16 FLUSHING & AERATOR CLEANING
After installation is complete, remove Spray Head (
16A
), by holding metal Hose Fitting
(
16B
) and turn Spray Head (
16A
) counterclockwise. Turn the Valve Lever Handles
(
16C
) to the full on position. Run water for one minute. While water is running, check
for leaks.
To clean the aerator, unscrew Aerator Housing (
16D
) from Spray Head (
16A
). Remove
Aerator Seal (
16E
) and Aerator Cartridge (
16F
) from Aerator Housing (
16D
). Clean
Aerator Cartridge (
16F
) and Aerator Housing (
16D
).
Reassemble by reversing steps.
Caution:
do not over tighten spray head and pull-out hose.
5
16B
16A
16C
16D
16F
16E
16C
17A
17F
17G
17F
17G
17C
17D
17A
17H
17A
17B
17B
17A
17E
18C
18D
18B
18A
18E
18F
18K
18J
18H
18G
