ENGLISH
ENGLISH
13
FAUCET FUNCTIONS
12
14
15
11
11 PULL-OUT HOSE ATTACHMENT
From underneath sink, push Quick Connector (
11A
), located on the end of the Pull-Out
Hose (
11B
) firmly upward onto the Receiving Tube (
11C
), until unable to push any further.
Pull down on the Quick Connector (
11A
). If the housing and the Inner Collet (
11D
) separate
slightly but do not pull off, the Receiving Tube (
11C
), quick connect is secure.
To remove Pull-Out Hose (
11B
), Push up on Quick Connector (
11A
). Holding Plastic Collet
(
11D
) in place, pull downward on Quick Connector (
11A
) until Tube (
11C
) is free.
12 WEIGHT ATTACHMENT
Discard Cardboard Fitting (
12B
) from Weight (
12A
). Place Weight (
12A
) above the
beginning of hose bend (
12C
) at the spout side (
as shown in shaded area
). Secure
Weight (
12A
) with Screws (
12D
).
13 UNIT START UP
Turn on hot and cold water supplies, and check for leaks above and below the sink.
14 FAUCET FUNCTION
COLD valve: close-counterclockwise, open-clockwise; HOT valve: close-clockwise,
open-counterclockwise. The Spout (
14A
) can be rotated around the Faucet Body in
any direction.
Note:
Flush faucet before turning on valve (
see step 16)
.
15 PULL-OUT OPERATION & SPRAY OPERATION
The Spray Head (
15A
) can be pulled forward to spray water in any direction.
To activate the spray mode, simply press Toggle Button (
15B
) located under the spray
head. You can change between spray and stream by pressing the opposite sides of the
Toggle Button (
15B/15C
) while the faucet is in operation. The water flow will increase
by sliding Spray Selector Switch (
15D
) from side to side (
in spray mode only
).
Note:
The faucet will always turn on in regular stream mode.
4
HOT
COLD
ON
ON
11A
11D
11D
11A
11C
11C
11A
11B
11C
12B
12A
12C
12D
14A
15C
15B
15D
15A
15A
