17
4. Power tool use and care
a) Do not force the power tool. Use the correct power tool for your application.
The correct power tool will do the job better and safer at the rate for which it was designed.
b) Do not use the power tool if the switch does not turn it on and off.
Any power
tool that cannot be controlled with the switch is dangerous and must be repaired.
c) Disconnect the plug from the power source and/or the battery pack from the power tool
before making any adjustments, changing accessories, or storing power tools.
Such
preventive safety measures reduce the risk of starting the power tool accidentally.
d) Store idle power tools out of the reach of children and do not allow persons unfamiliar
with the power tool or these instructions to operate the power tool.
Power tools are
dangerous in the hands of untrained users.
e) Maintain power tools. Check for misalignment or binding of moving parts, breakage of
parts and any other condition that may affect the power tools operation. If damaged,
have the power tool repaired before use.
Many accidents are caused by poorly maintained
power tools.
f) Keep cutting tools sharp and clean.
Properly maintained cutting tools with sharp cutting
edges are less likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits etc., in accordance with these instructions
and in the manner intended for the particular type of power tool, taking into account the
working conditions and the work to be performed.
Use of the power tool for operations
different from those intended could result in a hazardous situation.
5. Service
a) Have your power tool serviced by a qualified repair person using only identical
replacement parts.
This will ensure that the safety of the power tool is maintained.
b) If the replacement of the supply cord is necessary,
this has to be done by the
manufacturer or his agent in order to avoid a safety hazard.
6. Electrical safety
The tool is double insulated; therefore no earth wire is required. Always check that the
main voltage corresponds to the voltage on the rating plate.
Warning!
If the power cord is damaged, it must be replaced by the manufacturer, authorized
Black & Decker Service Center or an equally qualified person in order to avoid damage or
injury. If the power cord is replaced by an equally qualified person, but not authorized by
Black & Decker, the warranty will not be valid.
7. Labels on tool
The label on your tool may include the following symbols:
ENGLISH
Read instructions manual
Use eye protection
Use ear protection
V ........... Volts
A ........... Amperes
Hz ......... Hertz
W........... Watts
min........ minutes
........ Alternating current
........ Direct current
n
0
.......... No-Load speed
........ Class II construction
........ Earthing terminal
........ Safety alert symbol
.../min.... Revolutions or reciprocation
per minute
