23
ENGLISH
-
Do no
-
If an
t change the oil type. It may cause contamination by chemical
incompatibility, thus reducing its useful life and causing lubrication
problems.
oil type change occurs, carry out the first oil change after 2 working
hours and the other changes every 20 working hours or 2 months
(Whichever oc
change intervals.
curs first).
-IMPORTANT
Ask the nearest
Black&Decker
Authorized Service Center about
additional orientation on the adequate type of lubricant oil to be used.
3. Oil change procedures
A.
Change the oil according to the instructions below:
B.
Change Procedures:
-Unplug the equipment;
-Remove drain plug
14
and let the oil flow into a container;
-Fasten the plug using thread sealing;
-See the correct oil volume on Table 1 - Technical Characteristics - page 21;
-Replace the oil through the plug’s lodging orifice of the oil gauge
dipstick
15
, located on the crankcase (Picture 9) Table 4 shows the oil
TABLE 4 - OIL CHANGE INTERVALS
H11955F / H11957F
H11965F / H11967F
Mode
First change
Every 200 working hours
or 6 months
(whinchever occus first)
50 Working
hours
Other chages
4. Weekly
A.
B.
5. Every 15 (Fifteen) days
A.
6. Monthly
A.
7. Quarterly
A.
B.
8.
A.
B.
12
9.
Clean the compressor’s external surface with neutral detergent.
Remove air filter. Wash and dry the element.
Every 15 (fifteen) days, check the tightness of the compressor’s
fastening bolts and fasten them, if necessary (Picture 10). Use a
screwdriver according to the kind of bolts.
Check performance of pressure switch (see Items
5
and
6
of Start
Up Procedure).
Change the air filter every 300 hours (whichever occurs first).
Refasten bolts (see Table 5) and nuts.
Annually
Have the pressure switch, pressure gauge and ASME safety valve
calibrated either by an official institution, or according to local
Technical Norms and Legislation. This operation must be carried
out to a device not coupled to the air tank.
months or every 1000 hours (whichever occurs first), check and
clean the valves located between the cylinder' s upper part and its
cover. Do it at the nearest
Black&Decker
Authorized Service
Center, transportation costs are the responsibility of the customer.
Removing From Service (discard)
All compressed air systems contain maintenance parts (lubricating
OIL
PICTURE 9
PICTURE 10
PICTURE 11
TABLE 5 - BOLT TORQUE SPECIFICATIONS
SET
N . m
Lb . ft
12.0
3.0
9.0
2.2
CYLINDER HEAD
(M8 HEX.)
(M6 HEX.)
Note
-
Th
- Im
e above instructions are based on normal operation
conditions. If the compressor is installed in a polluted area,
increase the number of inspections.
portant:
Switch off the air compressor, remove the water and
exhaust the air from the tank at the end of every working day.
CORRECTIVE MAINTENANCE
SERVICE
TROUBLESHOOTING GUIDE
To assure product SAFETY and RELIABILITY, repairs,
maintenance and adjustment should be performed by
Black&Decker
Authorized Service Center always using identical
replacement original parts.
Please have the following information available for all service calls:
Model Number
Serial Number
Date and Place of Purchase
Proof of Purchase
This section provides a list of the more frequently encountered
malfunctions, their causes and corrective actions. The operator or
maintenance personnel can perform some corrective actions, and
others may require the assistance of a qualified
Black&Decker
technician.
Problem
Code
1, 2, 3, 4, 5, 7, 14, 15, 22
Problem
Code
6, 8, 9, 10, 11, 13, 16
Problem
Code
5, 6, 10, 11, 12, 13, 16, 20, 25
Problem
Code
5, 7, 10
Problem
Code
6, 9, 10, 12, 15, 16, 23
Problem
Code
15, 16, 17
Motor does not start or does not restart
(Do not insist to start the motor. Do it only after you have
discovered and eliminated the cause of the problem)
Reduce air production
(Pressure gauge keeps showing a lower pressure than that
of the job)
The compressor unit overheats
Electric motor overheats
Premature wear of the compressor unit internal parts
Abnormal noise or vibration
oil, filter) which are periodically replaced. These used parts may be,
or may contain, substances that are regulated and must be disposed
Of in accordance with local, state, and federal laws and regulations.
