20 • ENGLISH
4. While depressing the spindle lock button (5), tighten
the threaded clamp nut with included wrench.
5. To remove the wheel, depress the spindle lock button
and loosen the threaded clamp nut with included wrench.
Note: If the wheel spins after the threaded clamp nut is
tightened, check the orientation of the threaded clamp nut.
If a thin wheel is installed with the pilot on the clamp nut
against the wheel, it will spin because the height of the
pilotprevents the clamp nut from holding the wheel.
Surface grinding with grinding wheels
1. Allow the tool to reach full speed before touching the
tool to the work surface.
2. Apply minimum pressure to the work surface, allowing
the tool to operate at high speed. Grinding rate is
greatest when the tool operates at high speed.
3. Figure J: Maintain a 20˚ to 30˚ angle between the tool
and work surface.
4. Continuously move the tool in a forward and back
motion to avoid creating gouges in the work surface.
5. Remove the tool from work surface before turning tool
off. Allow the tool to stop rotating before laying it down.
MAINTENANCE
Cleaning
Warning! Blowing dust and grit out of the motor
housing using compressed air is a necessary maintenance
procedure. Dust and grit from metal grinding often
accumulate on interior surfaces and could create an
electrical shock hazard if not cleaned out.
Warning! Always use safety glasses. Everyday
eyeglasses are Not safety glasses. Also use face or dust
mask if operation is dusty. Always wear certified safety
equipment.
Use only mild soap and a damp cloth to clean the tool.
Never let any liquid get inside the tool; never immerse any
part of the tool into a liquid.
Important! To assure product Safety and Reliability,
repairs, maintenance and adjustment (other than those
listed in this manual) should be performed by authorized
service centers or other qualified service personnel,
always using identical replacement parts.
PROTECTING THE ENVIRONMENT
Separate collection. This product must not be
disposed of with normal household waste.
Should you find one day that your Black &
Decker product needs replacement, or if it is of
no further use to you, do not dispose of it with
household waste. Make this product available for
separate collection.
Separate collection of used products and
packaging allows materials to be recycled and
used again. Re-use of recycled materials helps
prevent environmental pollution and reduces the
demand for raw materials. Local regulations may
provide for separate collection of electrical
products from the household, at municipal waste
sites or by the retailer when you purchase a new
product.
SERVICE INFORMATION
Black & Decker offers a full network of company-owned
and authorized service locations. All Black & Decker
Service Centers are staffed with trained personnel to
provide customers with efficient and reliable power tool
service. For more information about our authorized
service centers and if you need technical advice, repair,
or genuine factory replacement parts, contact the
Black & Decker location nearest you, or visit us at
www.BlackandDecker-la.com
SPECIFICATIONS
G1000
Power
1000W
Voltage
AR
220V ~ 50Hz
B2C
220V ~ 50Hz
B3
120V ~ 60Hz
BR
127V ~ 60Hz
B2
220V ~ 60Hz
Speed
11000/min
Disc diameter
4-1/2” (115mm)
Disc bore
22mm
Spindle size
5/8″-11 / M14 (14mm)
