20 • ENGLISH
f
When servicing use only identical replacement
parts.
f
Always: wear eye protection, use guards, clamp
work in vise, use proper respiratory protection.
f
Do not expose to rain or use in damp locations.
f
Only use chop saw wheel of a max. Thickness of
2.8mm and a max. Diameter of 355mm.
WARNING SYMBOLS
Read
Instructions
Manual
Use Eye
Protection
Use Ear
Protection
V ........ Volts
A ........ Amperes
Hz ....... Hertz
W ........ Watts
min ..... minutes
..... Alternating
Current
..... Direct
Current
n
0
....... No-Load
Speed
...... Class II
Construction
.... Earthing
Terminal
.... Safety Alert
Symbol
.../min.. Revolutions
or Recipro-
cation per
minute
FEATURES (FIG. A)
1. Spark deflector screw
2. Spark deflector
3. Base
4. Fence
5. Vise
6. Flat Wrench
7. Crank
8. Vise Lever
9. Wheel
10. Guard
11. Spindle Lock
12. Depth Stop Bolt and Jam Nut
13. Trigger Switch
14. Padlock Hole
POWER SUPPLY
Be sure your power supply agrees with the nameplate
marking. A voltage decrease of more than 10% will cause
a loss of power and overheating.
Cutting capacity
The wide vise opening and high pivot point provide cutting
capacity for many large pieces. Use the cutting capacity
chart to determine total maximum size of cuts that can be
made with a new wheel.
Caution! Certain large, circular or irregularly
shaped objects may require additional holding means
if they cannot be held securely in vise.
Caution! Do not cut magnesium with this tool.
Maximum cutting capacity
Note: Capacity shown on chart assumes no wheel wear
and optimum fence position.
Workpiece
Shape
90° Cutting
Angle
45° Cutting
Angle
A = 4-7/8”
(125mm)
A= 4-1/2”
(115mm)
A = 4-1/2”
(115mm)
A = 3-13/16”
(98mm)
A x B
4-1/2” x 5-1/8”
(115mm x
130mm)
4” x 7-5/8”
(102mm x
188mm)
3” x 7-3/8”
(76mm x
229mm)
4-1/2” x 3-13/16”
4-1/8” x 3-3/4”
(105mm x
95mm)
A = 4-1/2” x
5-3/8”
(115mm x
137mm)
A = 3-13/16”
3-3/4”
(95mm)
USE
Standard equipment
1 14” Metal Cutting Abrasive Wheel
1 Wheel Wrench
1 Instruction manual
To carry (FIG. A)
Fold down unit to position where you can carry the saw.
Hook lock chain (24) to lock arm down.
Unlocking (FIG. A)
To unlock tool and raise head, depress motor arm slightly
and unhook lock chain (24) out. Motor arm will then pivot
upward.
Depth stop (FIG. A)
Depth stop is set at the factory for a new 14” wheel to
prevent wheel from cutting into the supporting surface.
To allow more depth of cut, use the flat wrench provided
(7) to loosen the depth stop bolt (13) and raise bolt to
desired height and then turn jam nut (13) clockwise until
seated firmly on the casting. Securely tighten the depth
stop bolt before use.
