ENGLISH
(Original instructions)
9
NEVER dispose of batteries in fire, as they may leak
and explode.
ALWAYS remove exhausted batteries from product.
Batteries are to be inserted following the polarity
markings on the product.
Remove batteries before extended storage.
♦
To begin using this air conditioning unit, start by
installing the batteries in the remote control.
♦
To install the batteries, first detach the battery
cover from the remote. To do this, place your
finger on the grooved area at the centre of the
battery cover and push down and away from the
body of the remote.
♦
Insert 2 x AAA batteries into the battery
compartment, taking care to ensure the polarities
are correct.
♦
Once the batteries have been correctly inserted,
replace the battery cover by aligning each of the
locking tabs with the corresponding notch on the
remote control body and pushing it upwards until it
clicks into place.
♦
The remote control is now ready for normal use.
Assembling Your 3-in-1 Air Conditioner
WARNING: Before performing any assembly or
maintenance, switch the unit off and remove it from
the power supply.
Installing the Window Hose
♦
Before using your air conditioning unit, you will
need to install the window hose so that hot air
from the appliance is released onto an outside,
open-air area. The sections below illustrate the
correct way to attach and install the window hose.
♦
To install the window hose through a wall, first cut
a hole approximately 152mm in diameter in the
wall or window through which you wish to feed the
window hose.
♦
Feed the window hose through the window or wall
and attach the threaded adaptor from the outside
as shown.
♦
Your air conditioner is now ready for use.
Note!
When not using the air conditioner, plug the
hole with the cover provided.
Mounting the Window Hose
♦
To mount the window hose, clip it to the back of
the air cooling unit. Take care to avoid any bends
or kinks as this could cause the pipe to clog,
resulting in overheating and potential malfunction.
