Black & Decker BDCS80I, Instruction Manual

Page: 8 / 32

trouBlesHooting
problem possible cause possible solution
• Unit will not start. • Battery pack not charged. • Check battery pack charging
requirements.
• Battery pack will not charge. • Charger not plugged in. • Plug charger into a working outlet.
Refer to “Important Charging Notes” for
more details.
• Surrounding air temperature • Move charger and battery pack to a
too hot or too cold. surrounding air temperature of above
40 degrees F (4.5°C) or below
105 degrees F (+40.5°C).
For assistance with your product, visit our website www.blackanddecker.com for the
location of the service center nearest you or call the BLACk+DECkER help line at
1-800-544-6986.
accessories
Recommended accessories for use with your tool are available from your local dealer or
authorized service center. If you need assistance regarding accessories, please call:
1-800-544-6986.
warning:
The use of any accessory not recommended for use with this tool could
be hazardous.
rBrc seal
tM
The RBRC™ (Rechargeable Battery Recycling Corporation) Seal on the
lithium-ion battery (or battery pack) indicates that the costs to recycle the
battery (or battery pack) at the end of its useful life have already been paid
by BLACk+DECkER. In some areas, it is illegal to place spent lithium-ion
batteries in the trash or municipal solid waste stream and the RBRC program
provides an environmentally conscious alternative.
RBRC in cooperation with BLACk+DECkER and other battery users, has established
programs in the United States and Canada to facilitate the collection of spent lithium-ion
batteries. Help protect our environment and conserve natural resources by returning the
tool to an authorized BLACk+DECkER service center for recycling. You may also contact
your local recycling center for information on where to drop off the spent battery, or call
1-800-8-Battery.
note: Batteries are integrated into the tool and should not be removed. To recycle, return
the tool to an authorized BLACk+DECkER service center.
This Class B digital apparatus complies with Canadian ICES-003.
This device complies with part 15 of the FCC rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in
a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
8