Black & Decker BDCS80I, Instruction Manual

Page: 7 / 32

trigger switcH & reversing Button (figure c)
• The drill is turned ON and OFF by pulling and releasing
the trigger (1).
• A forward/reverse control button (2) determines the
direction of the tool and also serves as a lock off button.
• To select forward rotation, release the trigger switch and
depress the forward/reverse control button to the left.
• To select reverse, depress the forward/ reverse control
button the opposite direction.
• To avoid being turned on accidentally, do not carry in your
pocket.
note: The center position of the control button locks the tool in the off position.
When changing the position of the control button, be sure the trigger is released.
screw driving
For driving fasteners, the foward/reverse button should be pushed to the left. Use reverse
(button pushed to the right) for removing fasteners. When moving from forward to reverse,
or vice versa, always release the trigger switch first. Release trigger when the fastener is at
the desired depth.
note: For best performance, use 2” fasteners or smaller, or
screw into pre-drilled holes.
note: The impact mechanism of the screwdriver creates a
loud, impacting noise when extra force is needed. This noise
is normal; the screwdriver is not malfunctioning or broken.
iMpact driver warnings:
• Hold the tool as shown in figure d.
• Do not use tool as a pry bar.
• To avoid being turned on accidentally, do not carry in your
pocket.
on Board Bit storage (figure e)
A magnetic bit holder(4) is built-in to the area on top of the
screwdriver for easy storage and access.
drilling
• Use sharp drill bits only.
• Screwdriver is ideal for bits 1/4” or smaller.
• Support and secure work properly, as instructed in the
Safety Instructions.
• Use appropriate and required safety equipment, as
instructed in the Safety Instructions.
• Secure and maintain work area, as instructed in the Safety Instructions.
• Apply pressure in a straight line with the bit. Use enough pressure to keep the bit biting
but not so much as to stall the motor or deflect the bit.
• DO NOT CLICK THE TRIGGER OF A STALLED SCREWDRIVER OFF AND ON IN AN
ATTEMPT TO START IT. DAMAGE TO THE SCREWDRIVER CAN RESULT.
• Minimize stalling on breakthrough by reducing pressure and slowly drilling through the
last part of the hole.
• Keep the motor running while pulling the bit out of a drilled hole. This will help reduce
jamming.
• Make sure switch turns screwdriver on and off.
Maintenance
Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.
IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and
adjustment (other than those listed in this manual) should be performed by authorized
service centers or other qualified service personnel, always using identical replacement parts.
7
e
d
c
1
2