Black & Decker BD61516, Instruction Manual

Page: 8 / 20

Page 8
Door hole
plug
SET UP & USE
PROTECTION FROM HEAT AND MOISTURE
• Do not install your Wine Cellar in any location where heavy moisture
is present or if the location is not properly insulated. This Wine
Cellar is not designed to operate in temperature setting below 55°
Fahrenheit.
• Location for the Wine Cellar should be on a hard surface and away
from direct sunlight and heat source, e.g., radiators, baseboard
heaters, cooking appliances, etc.
REVERSING THE DOOR HINGE
(MODEL BD61516)
1. Remove the top hinge cover.
2. Using a Phillips Head Screwdriver, loosen and remove the 2 screws
holding the top hinge in place.
3. Remove top hinge and carefully lift off the door.
4. Remove the screw hole plugs from the opposite side of the cabinet
and the door and insert the plugs in the screw hole openings of the
just removed screws.
5. Remove any loose items in the wine cellar and carefully place the
wine cellar on its back.
6. Loosen the screws holding the lower hinge bracket to the wine cellar
and remove screws and bracket.
7. Remove (2) screws from the other side and insert in the previously
removed screw holes. Tighten the screws.
8. Remove the door pin from the lower hinge bracket by turning it
counter-clockwise. Turn over the bracket, then reinsert the door pin
into the threaded hole, and tighten.
9. Align the door with the cabinet first. Then install the lower hinge
bracket to the bottom opposite side of the cabinet. Then insert (2)
remaining screws into the holes. Tighten the screws.
10. Align top hinge bracket with screw holes, insert screws and partially
secure, check that door and cabinet are properly aligned and then
secure tightly.
11. Align upper hinge bracket with screw holes insert screws and
partially secure, check that door and cabinet are properly aligned
and then secure tightly.